Transport
Refrigeration
Solutions

Range overview

FK Series

For rigids

The right refrigeration unit for high-end distribution service, mounted to the front wall above the driver’s cab. The evaporator is completely integrated in the refrigeration unit allowing double-deck loading up to the front wall without loss of loading height while protecting the load from damage. Quick-release fasteners improve ease of maintenance and the refrigeration unit can be exchanged within a few minutes.

HK Series

FOR SEMI-TRAILERS AND DRAWBAR COMBINATIONS

The ideal front-mount refrigeration unit for drawbar systems and semi-trailers. The cross-flow fan with only 100 mm discharge height ensures optimum volumetric airflow and high discharge velocity. The complete unit can be hinged out offering easy and full maintenance accessibility even when the truck is loaded.

EK/DK Series

UNDERMOUNT & ROOF-INTEGRATED SPLIT REFRIGERATION UNITS

Trucks with low body or through-loading trailer can be equipped with a split refrigeration machine where the condenser unit EK is underfloor mounted and the evaporator unit RE is installed in the loading space.
The condenser unit DK, on the other hand, can be integrated fully into the roof and with the evaporator unit RE is ideal for large-volume truck-trailer combinations and swap bodies.

RE Series

ADDITIONAL EVAPORATORS FOR MULTI-COMPARTMENT SOLUTIONS

The FRIGOBLOCK RE 11-44 models are not only suitable as evaporators in the split EK/DK + RE combinations but also as additional evaporators for multi-compartment trucks. Double-deck loading or multi-compartment bodies divided longitudinally in three sections can be successfully realised due to the low height of 100 mm and higher, width of 720 mm and wider.

Alternators

3-PHASE ALTERNATOR SYSTEMS

As early as the 1970s, FRIGOBLOCK had started work on the development of an alternator drive system. Via a V-Belt from the truck engine, this system produces the same voltage and frequency on-board as the European power supply system. This means there is no problem to run FRIGOBLOCK units on a mains supply without the need for any additional equipment.

FK Series

This front wall mounted unit located above the driver’s cab meets the high demands of distribution traffic. An integrated evaporator lets you load right up to the front wall without losing loading height or damaging the evaporators or the load. The FKi Series features integrated inverters for rigid trucks with multiple internal evaporators.

  • HIGH CAPACITY
  • UP TO 50% LESS FUEL CONSUMPTION
  • INTEGRATED EVAPORATOR
  • HIGH EFFICIENCY
  • LOW GWP REFRIGERANT R 410A
  • HYDRAULIC TILTING MECHANISM SAVES UP TO 300 MM TOTAL HEIGHT

HK Series

This front wall mounted refrigeration unit keeps your drawbar combinations and semi-trailers at the right temperature. The integrated evaporator lets you use all your precious loading space. The
complete unit can be hinged open for easy and full maintenance accessibility, even when your trailer is fully loaded.

  • HIGH CAPACITY
  • UP TO 50% LESS FUEL CONSUMPTION
  • LIGHT WEIGHT, HIGH PERFORMANCE
  • 4-WAY HEAT PUMP CONTROL FOR RAPID DEFROST CYCLES
  • LARGE HEAT EXCHANGE SURFACES WITH HIGH EFFICIENCY
  • LOW GWP REFRIGERANT R 410A

EK/DK Series

For your low-height truck bodies or through-loading trailers, FRIGOBLOCK devised a split refrigeration transport solution consisting of the underfloor-mounted EK condenser and the RE evaporator. If you require temperature control in large-volume truck-trailer combinations and swap bodies, you can fully integrate the DK refrigeration unit and the RE evaporator into the roof of the body.

  • HIGH CAPACITY
  • UP TO 50% LESS FUEL CONSUMPTION
  • HIGH EFFICIENCY
  • LOW GWP REFRIGERANT R410A
  • LIGHT WEIGHT AND COMPACT DESIGN

RE Series

Our ultra-slim evaporators can be used in the split combination EK/DK + RE, but also when you need additional zones in your multi-compartment trucks. Thanks to their compact design, a multitude of multi-compartment solutions are possible with optimum load space.

  • MAXIMUM FLEXIBILITY
  • 4-WAY HEAT PUMP CONTROL FOR EXTREMELY FAST DEFROSTING
  • RADIAL FLAT FAN FOR OPTIMUM AIR THROUGHPUT
  • HIGHLY DURABLE AND ULTRA-SLIM

Alternators

With more than 40 years of experience, Frigoblock is the leading producer of alternator drive systems approved by leading truck manufacturers.

  • HIGH EFFICIENCY AND CAPACITY
  • COMPACT DESIGN
  • LIGHT WEIGHT
  • EXTENDED LIFETIME
  • EASY INSTALLATION
Loading...